INSTALLATION AR-ENGINE 3081236 - Caterpillar

Illustration 78 g00570262
Illustration 79 g00570264
Install guide bolt (165). Place manifold (166) into position. Install four bolts (167) and the washers that secure the manifold to housing assembly (163) .
Check the remaining clutch packs. Refer to Step 99 for the proper procedure.
Illustration 80 g00570265
Illustration 81 g00570267
Install two forged eyebolts to transmission case (168). The forged eyebolts must have the following dimensions: 5/8 inch - 11 NC. Attach a hoist and raise the transmission case over the planetary assembly. The weight of the case is 204 kg (449.7 lb). Install two guide bolts (169). The guide bolts should have the following dimensions: 5/8 inch - 11 NC. Lower the transmission case onto the planetary assembly.
Install the 24 bolts and the washers that secure case (168) to the planetary assembly.
Illustration 82 g00571958
Use a hydraulic press in order to install bearing (170) onto shaft (171) .
Illustration 83 g00571956
Use Tooling (B) in order to install snap ring (172) .
Illustration 84 g00571995
Install shaft (171) into cover (173) .
Illustration 85 g00571961
Use Tooling (E) in order to install a new seal to retainer (174) .
Illustration 86 g00582070
Install O-ring (175) to retainer (174) .
Illustration 87 g00571963
Place retainer (174) into position on cover (173). Install six bolts (176) .
Illustration 88 g00570268
Illustration 89 g00570269
Install O-ring (177) and O-ring (178) .
Install two forged eyebolts onto cover (173). The forged eyebolts must have the following dimensions: 5/8 inch - 11 NC. Attach a hoist and position the cover onto planetary assembly.
Illustration 90 g00570271
Install 14 bolts (179) and the washers that secure cover (173) to the planetary assembly.
Illustration 91 g00572005
Install yoke (180) onto shaft (171) .End By: Connect the transmission and transfer gears. Refer to Disassembly and Assembly, "Transmission and Transfer Gears - Connect".