INSTALLATION AR-CEM 3980024 - Caterpillar

Introduction
This section discusses the Setup Menu dialogs. Use these dialogs in order to access the AccuGrade System setup items.Note: The contents of the "Setup Menu" dialog are site configurable. Depending on the Operator Configuration settings of your system and machine settings, the number of items in the "Setup Menu" may vary.Table 1 lists the default menu items.Table 2 lists the additional menu items.
Table 1
Setup Menu - Configuration Default Menu Items    
Menu Item     Description    
Blade Wear     Blade wear information is entered into the AccuGrade System so that the AccuGrade System can adjust for the wear of the cutting edge.    
Diagnostics     The software for the AccuGrade System displays diagnostic information about the devices the software detects and also the GPS receiver.    
GPS Accuracy Mode     GPS Accuracy mode is used in order to set the maximum GPS error estimate that is acceptable for your application.    
Light Bar Scales     The Light Bar Scales dialogs set the vertical and horizontal tolerances that apply to the LEDs on the light bars.    
Restore Settings     Use the Restore Settings dialog in order to restore previously saved display settings or machine settings.    
Valve Speed     The Valve Speed dialog