INSTALLER AS 2626020 - Caterpillar

Illustration 7 g00520401
Transmission control linkage (1) Knob (2) Lever (3) Locknut (4) Governor control lever (5) Rod end (6) Rod (7) Lever (8) Rod end (9) Lever (10) Rod (11) Rod end (12) Rod end (13) Underspeed override valve lever
To adjust lever force, remove the cover on the left side control console.
Adjust locknut (3) until the force that is required to move lever (2) at knob (1) is 40 4 N (9 0.9 lb).
Move lever (2) into the HIGH IDLE detent.
Adjust rod ends (5) and (11) so that rod (6) fits freely between lever (9) and governor lever (4). The governor lever must be in the HIGH IDLE detent.
Illustration 8 g00520467
Governor control linkage (4) Governor lever (5) Rod end (6) Rod
Rotate rod end (5) clockwise for an additional two full turns in order to engage the overtravel spring of the governor control in HIGH IDLE.
Adjust rod ends (8) and (12) so that rod (10) fits freely between lever (7) and underspeed override valve lever (13). The underspeed override valve lever is located on the back left side of the hydrostatic transmission. The underspeed override valve lever is connected to rod end (12) .
The underspeed override valve lever (13) has an internal spring bumper inside the hydrostatic transmission.
The underspeed override valve lever must be held against this spring bumper.
When the governor control linkage and the linkage for the underspeed override valve are adjusted correctly, tighten the locknuts.Note: Use caution in order to not compress the internal bumper spring.Steer Control Linkage Adjustment
Illustration 9 g00520476
Steer control linkage (1) Bolt (2) Zero steer adjustment screw (3) Rod (4) Rod end (5) Lever
Illustration 10 g00520497
Steer control linkage (1) Bolt (2) Zero steer adjustment screw (3) Rod (4) Rod end (5) Lever (6) Pin (7) Rod (8) Rod end (9) Pin (10) Lever (A) 91 2 mm (3.58 0.08 inch)Note: Raise the cab, if necessary.
Adjust zero steer adjustment screw (2) in order to attain dimension (A) of 91 2 mm (3.58 0.08 inch).
If necessary, loosen bolt (1) on one pedal. Adjust the pedal angle so that both of the angles are the same angle.
Lift up steering lever (5) until contact is felt.
Hold the lever in this position and adjust rod end (4) until pin (6) fits freely into rod end (4) and lever (5) .
Increase the length of rod (3) by turning rod end (4) counterclockwise for an additional three turns.
Install pin (6) and tighten the nut on rod end (4) .
Perform similar action to Step 3 for the following components: rod (7), rod end (8), pin (9) and lever (10) .
Illustration 11 g00520520
Cross section through pedal control (2) Zero steer adjustment screw
Speed Override and Brake Control Linkage Adjustment
Illustration 12 g00520533
Linkage for Speed Override and Brake Control (1) Brake pedal (2) Plunger assembly (3) Locknut (4) Locknut (5) Setscrew (6) Rod end (7) Locknut (8) Bolt (9) Lever for brake valve spool (10) Rod (A) 160 5 mm (6.3 0.2 inch) (B) 40 3 mm (1.6 0.1 inch)Note: If necessary,