INSTALLER-SEAL 6V2087 - Caterpillar

Illustration 1 g00549442Note: The display first shows the present setting. The default setting is displayed on the message center when a new source has been loaded or a new configuration has been loaded. The previous example reflects the default setting of "1.1-2 SNAPSHOT FULL".
The arrow keys are used to move through the list of available settings. The "OK" key selects the desired setting.
Illustration 2 g00487242
Press the right arrow key in order to advance to next setting.
Illustration 3 g00487243
Press the right arrow key in order to advance to next setting.
Illustration 4 g00487244
Press the right arrow key in order to advance to next setting.
Illustration 5 g00487245Note: If the right arrow key is pressed again the list remains at the last setting. Press the left arrow key in order to move back through the settings.
Press the "OK" key in order to accept the setting when the desired "Service Lamp Setting" is displayed on the message center. The option that was selected is now the new mode for service indicator lamp.
Illustration 6 g00487244Note: The setting of the service indicator lamp is set to option 4. The title of option 4 is "DAMAGE EVENTS ONLY". This setting will be used for all operations until one of the following events occur:
New flash software is loaded.
The user selects a new setting with VIMSpc. The service tool (VIMSpc) must be connected to the machine.Table 1 summarizes the behavior of the service indicator lamp in the five lamp setting modes.
Table 1
Behavior of the Service Indicator Lamp
"Choice No." Lamp Setting Mode "Damage Event" "Active Event" "2nd Snapsot Full" "1st Snapshot Full"
1 "1-2 Snapshot Full" Flashing ON “Flashes Every Five Minutes ” “Flashes Every 10 Minutes”
2 "2 Snapshots Full" Flashing ON “Flashes Every Five Minutes ” OFF
3 "No Snapshot Notice" Flashing ON OFF OFF
4 "Damage Events Only" Flashing OFF OFF OFF
5 "Never On" OFF OFF OFF OFF