INSTALLER 8M7911 - Caterpillar

Illustration 9 g01065910
Do not attempt to remove spring(s), they are not serviceable. Do not cut, saw, torch or modify this chamber, serious injury or death may result.
High-Pressure Cylinder (9)Safety message (9) is attached inside the outside cover for each track roller frame.
Illustration 10 g01783633
Personal injury or death can result from grease under pressure.Grease coming out of the relief valve under pressure can penetrate the body causing injury or death.Do not watch the relief valve to see if grease is escaping. Watch the track or track adjustment cylinder to see if the track is being loosened.Loosen the relief valve one turn only.If track does not loosen, close the relief valve and contact your Caterpillar dealer.
Explosion Hazard (10)Safety message (10) is located near the engine.
Illustration 11 g01372254
Explosion Hazard! Spraying uncontrolled ether into the air inlet system can cause explosions or fire that may result in personal injury or death. Read and follow the starting procedures in the Operation and Maintenance Manual.
High-Pressure Fuel Lines (11)Safety message (11) is located near the engine.
Illustration 12 g01381180
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death.
Do Not Operate (12)Safety message (12) is located inside the engine compartment.
Illustration 13 g01370904
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in serious injury or death.
Rotating Fan (13)Safety message (13) is on the front of the cooling system fan door.
Illustration 14 g02176339
Rotating fan blades can result in personal injury or death.Stop the engine and allow the fan to come to a complete stop before making any test or adjustment.Before starting the engine, make sure all of the finger guards are installed and the guard door is closed. Do not allow any tools or test equipment to protrude or vibrate into the path of the rotating fan blades.
Hot Fluid Under Pressure (14)Safety message (14) is located in two places. One location is under the access door to the radiator cap. The other location is outside the access door in the front bottom guard.
Illustration 15 g01371640
Pressurized system! Hot coolant can cause serious burns, injury or death. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Read and understand the Operation and Maintenance Manual before performing any cooling system maintenance.