INSULATION 1247329 - Caterpillar

Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Improper operation of an access platform could result in injury or death. Operators must carry out their duties properly and follow all instructions and guidelines given for the machine and access platform.
Accidental engine starting can cause injury or death to personnel working on the equipment.To avoid accidental engine starting, disconnect the battery cable from the negative (−) battery terminal. Completely tape all metal surfaces of the disconnected battery cable end in order to prevent contact with other metal surfaces which could activate the engine electrical system.Turn the battery disconnect switch to the OFF position and lockout the battery disconnect switch with a safety lock.Place a Special Instruction, SEHS7332, "Do Not Operate" tag at the start switch and battery disconnect location to inform personnel that the machine is being worked on.
Safety Messages
The warning film in Illustration 1 can be found in a location such as the dash or control panel. The warning film is clearly visible to the operator during the normal operation of the equipment.
Illustration 1 g03356592
Film
This equipment is equipped with a Cat® Product Link communication device. When electric detonators are being used for blasting operations, radio frequency devices can cause interference with electric detonators for blasting operations which can result in serious injury or death. The Product Link communication device should be deactivated within the distance mandated under all applicable national or local regulatory requirements. In the absence of any regulatory requirements Caterpillar recommends the end user perform their own risk assessment to determine safe operating distance.
The blast site is defined as the area that handles explosive material during loading. Included is the perimeter that is formed by the loaded blast holes.If required, the following are suggested methods to disable the Caterpillar Product Link communication device:
Turn the Product Link radio disable switch to the OFF position.
Disconnect the Caterpillar Product Link communication device from the main power source. This action is performed by disconnecting the wiring harness at the Product Link radio.Note: If no radio disable switch is installed and the equipment will be operating near a blast zone, a radio disable switch may be installed. The switch will allow the Caterpillar Product Link communication device to be shut off by the operator from the equipment control panel. Refer to Special Instruction, REHS7339, Special Instruction, REHS8850, Special Instruction, REHS9111, Special Instruction, SEHS0377, and Special Instruction, REHS9757 for more details and installation instructions.Other Films
The film in Illustration 2 can be found in a location such as the dash or control panel. The warning film is clearly visible to the operator during the normal operation of the equipment.
Illustration 2 g03356733The film in Illustration 2 is intended to inform the operator that the equipment is equipped with a wireless transmitting device. Accordingly, data