INSULATION 2412252 - Caterpillar

The blast site is defined as the area that handles explosive material during loading. The blast site includes the perimeter that is formed by the loaded blast holes.If the machine is required to work in or near a blasting site, then the operator must disable the Product Link PL121SR. One of the following methods are suggested in order to deactivate the Product Link PL121SR:
Install a Product Link disconnect switch in the machine cab that will allow the Product Link PL121SR module to be shut off. Refer to Special Instruction, REHS2365, "An Installation Guide for the Product Link PL121SR and for the PL300" for more details and installation instructions.
Disconnect the Product Link PL121SR module from the main power source by disconnecting the wiring harness at the Product Link module.Other Films
Illustration 2 g01787075
The film in Illustration 2 can be found in a location such as the dash. A place that is clearly visible to the operator during the normal operation of the machine.The film is intended to inform the operator that the machine is equipped with a wireless transmitting device. The wireless transmitting device transmits the following:
Data concerning this machine
The machines condition
The machines operation is being transmitted by Product Link to Caterpillar and/or Caterpillar dealersThe data transmitted is used to serve the customer better and to improve upon Caterpillar products and services.Transmission of information using Product Link is subject to legal requirements that may vary from location to locationRefer to the ""Operation Section"" and the ""Regulatory Compliance Section"" for additional information.
Illustration 3 g01787076
This film is located near the Product Link disconnect switch (if equipped). This film is only required for versions of software prior to 3118375.fls and 3118377.smp.The keyswitch should be placed in the OFF position for a minimum of 10 seconds before placing the Product Link disconnect switch in the OFF position. Failure to place the keyswitch in the OFF position for a minimum of 10 seconds may cause the current parameters of "SMU, location, etc." to be lost and/or corrupted.Note: While the blast site switch is in the OFF position, the PL121/PL321 will no longer track Service Meter Unit (SMU) hours. An SMH adjustment will be required after power is restored to the Product Link. Consult your Caterpillar dealer if there are any questions.Operation Section
The Product Link PL121SR is a satellite-based communication device that transmits information regarding the machine to Caterpillar, Caterpillar dealers and Caterpillar customers. The unit contains a Global Positioning System (GPS) satellite receiver and a low earth orbit communication satellite transceiver.The Product Link PL121SR system has the capability of two-way communication between the machine and a remote user. The remote user can be a dealer or a customer. At any time, a user can request updated information from a machine such as hours of use or the location of the machine. Also, the system parameters for Product Link PL121SR can be changed. Data is transmitted from the machine to a satellite. Next, the data is transmitted to a ground station. The receiving station transmits the data to