INSULATION-SOUND SUPPRESSION 4250616 - Caterpillar

To minimize transportation height, the machine is transported with the secondary conveyor in the folded position.
Verify that all the controls/switches are in the OFF position and the parking brake is applied.
Start the engine.
Illustration 16 g06011064
Press the electric circuits enable switch (1).
Park the machine on solid, level ground and make sure that there is open space of 10 m (33 ft) at the front and back of the machine and at least 3 m (10 ft) on each side.
Illustration 17 g06011070
Use the secondary conveyor control lever (2) to swing the secondary conveyor to the center position.
Using the Main Machine Height Control lever, Lower the front of the machine down to minimum height.
Illustration 18 g06011072
Check that the conveyor cables (3) are not under tension and then release the cables by pulling out the lock pins and the retaining pins (4).
Use the secondary conveyor control lever (2) to lower the conveyor until approximately 1 m (3.3 ft) from the ground.
Illustration 19 g06011107
Extend the secondary conveyor supports (5) from the storage position to the operating position.
Use the secondary control positioning lever (2) to lower the conveyor slowly, until the weight of the conveyor is supported by the supports (5).
Illustration 20 g06011108
Unlatch both pins (6) from the holes on each side of the secondary conveyor.
Illustration 21 g06011111
Move the propel speed selector (7) to the slow speed position.
Illustration 22 g06011112
Use the secondary conveyor control lever (2) to raise the conveyor slowly, until the upper half (8) is in the vertical position as shown, and move the secondary conveyor supports (5) from the operating position to the storage position. At the same time, operate the propel control lever and move the machine slowly in the forward direction to fold the secondary conveyor frame.
After passing the vertical position and when continuing to move the machine forward, move the secondary conveyor control lever (2) to lower the conveyor slowly, until the conveyor is fully folded. Once the conveyor is fully folded, release the secondary conveyor control lever (2) and move the propel lever to the NEUTRAL position to stop the machine.
Illustration 23 g06011114
Install lock bar (9) as shown to secure the conveyor in the folded position.
Return the supports (5) to the storage location.
Attach the secondary conveyor support cables (3) by installing the retaining pins and installing the lock pins (4).
The secondary conveyor is now folded.Hydraulic Foldable Canopy
Closing the Canopy
Illustration 24 g06011117
Illustration 25 g06011120
On both canopy supports, rotate both locking cams (2) to the fully UP position.
Move the Canopy Raise/Lower Switch (1) down to lower the canopy.Opening the Canopy
Illustration 26 g06011117
Illustration 27 g06011120
Move the canopy Raise/Lower Switch (1) UP and fully raise the canopy to the fully raised position.
On both canopy supports, rotate both locking cams (2) to the full DOWN and LOCKED position.