INSULATOR 0385158 - Caterpillar

Note: Put identification marks on all lines, on all hoses, on all wires and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Illustration 1 g00843102
Remove four bolts (1), the washers, and guard (2) .
Remove ladder assembly (3) .
Illustration 2 g00843117
Attach a suitable hoist and lifting slings to fender assembly (4), as shown.
Illustration 3 g00843119
Remove bolts (5) and the washers.
Illustration 4 g00843120
Remove bolts (6), (7), and (8) .
Use the hoist in order to remove fender assembly (4). The weight of fender assembly (4) is 86 kg (190 lb).
Illustration 5 g00843137
Disconnect two hose assemblies (9) .
Remove tube assembly (10) .
Disconnect electrical connector (11) .
Remove bolts (12) and the washers that hold the mounting plate to the fuel tank.
Illustration 6 g00360853
Place wood blocks under the mounting plate, as shown.
Remove two bolts (14), the washers, and parking brake control valve (13) .Installation Procedure
Illustration 7 g00360853
Install parking brake control valve (13), two bolts (14), and the washers.
Remove the wood blocks.
Illustration 8 g00843137
Install bolts (12) and the washers that hold the mounting plate to the fuel tank.
Connect two hose assemblies (9) .
Install tube assembly (10) .
Connect electrical connector (11) .
Illustration 9 g00843117
Attach a suitable hoist and lifting slings to fender assembly (4), as shown.
Use the hoist in order to install fender assembly (4). The weight of fender assembly (4) is 86 kg (190 lb).
Illustration 10 g00843119
Install bolts (5) and the washers.
Illustration 11 g00843120
Install bolts (6), (7), and (8) .
Illustration 12 g00843102
Install ladder assembly (3) .
Install four bolts (1), the washers, and guard (2) .End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".