INSULATOR 3376729 - Caterpillar

Remove seal ring (21) from shaft (16).
Remove bearing (20) from the shaft.
When the component is removed, the component is damaged.
Remove bearing race (18) from the shaft, when removal is necessary.
Illustration 9 g00495647
Remove remaining bolts (15) with the washers. Install two 3/8 inch by 16 NC forcing screws (23) in impeller wheel (22).
Install Tooling (D) and attach a hoist to the impeller. Tighten the two forcing screws evenly, and remove the impeller wheel with the carrier. The weight of the impeller wheel with the carrier is approximately 30 kg (65 lb).
Use care in disassembly of the torque converter, in order to avoid damage to the stator.
Illustration 10 g00629884
Illustration 11 g00533434
Remove bolts (24). Remove stator (25).
Support the unit of the wheel and of the carrier close to the center. Use wood blocks or use a holding tool. Use Tooling (E) on the inside diameter of pins (26). Remove carrier (27).
Remove seal ring (28) and pins (26) from the carrier.
Illustration 12 g00533436
Remove the bolts that fasten retainer (29) to the impeller wheel. Use two 3/8 inch by 24 NF forcing screws to remove retainer (29).
Use Tooling (F) to remove carrier (30) with the bearing.
Illustration 13 g00533437
Use Tooling (F) to remove bearing (31) from carrier (30).
Illustration 14 g00533439
Use Tooling (G) to remove retaining ring (33) from the output flange.
Remove turbine wheel (32) from housing (34) and from the output flange. Remove the spacer that is under turbine wheel (32).
Illustration 15 g00533442
Turn over the housing. The weight of the housing is approximately 35 kg (75 lb). Remove two stop pins (35).
Compress the retaining ring. Remove ring gear (36). Remove the retaining ring.
Illustration 16 g00533443
Install two 3/8 inch by 16 NC forcing screws in output flange (37). Tighten the two forcing screws evenly, and remove the output flange from the housing.
Illustration 17 g00533449
Remove seal (40) from carrier (39) on output flange (37).
When the component is removed, the component is destroyed.
When removal is necessary, use a chisel to break carrier (39). Remove the carrier.
Use Tooling (E) to remove two bearings (38) from output flange (37).
Illustration 18 g00533452
Remove bolts (46) and retainer (41) from the housing.
Illustration 19 g00533453
Use Tooling (F) to remove bearing (42) from housing (34).