INSULATOR 7T3454 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 185-3630 Strap Wrench As 1
Ensure that all adjustments and repairs that are carried out to the fuel system are performed by authorised personnel that have the correct training.Before begining ANY work on the fuel system, refer to Operation and Maintenance Manual, "General Hazard Information and High Pressure Fuel Lines" for safety information. Refer to System Operation, Testing and Adjusting, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Note: Identify the position on the hose assembly in order to show the correct position of the tube assembly. Plug all hose assembly. Cap all connections on the fuel filter base assembly.
The engine can have the ability to auto start. Ensure that the power supply is isolated before any service or repairs is performed.
Turn the fuel supply to the OFF position.
Illustration 1 g01663713
Use Tooling (A) to remove fuel filters (8). Refer to Operation and Maintenance Manual, "Fuel System Primary Filter - Replace".
Make temporary identification marks on hose assembly (1) and hose assembly (2). Disconnect hose assembly (1) and hose assembly (2) from fuel filter base (3). Note: Plug hose assemblies. Cap all connections on the fuel filter base assembly.
Make temporary identification marks on hose assembly (5). Disconnect hose assembly (5) from fuel filter base (3). Note: Plug hose assemblies. Cap all connections on the fuel filter base assembly.
Make temporary identification marks on tube assembly (6). Disconnect tube assembly (6) from fuel filter base (3). Note: Plug hose assemblies. Cap all connections on the fuel filter base assembly.
Remove bolts (9) from fuel filter base (1). Remove the fuel filter base from mounting bracket (4). Note: Do not disassemble the fuel filter base.Installation Procedure
Ensure that all adjustments and repairs that are carried out to the fuel system are performed by authorised personnel that have the correct training.Before begining ANY work on the fuel system, refer to Operation and Maintenance Manual, "General Hazard Information and High Pressure Fuel Lines" for safety information. Refer to System Operation, Testing and Adjusting , "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system.
Ensure that the fuel filter base is clean and free from damage. If necessary, replace the complete fuel filter base and filter assembly.
Illustration 2 g01663713
Position fuel filter base (3) onto mounting bracket (4). Install bolts (9). Tighten the bolts to a torque of 44 N m (33 lb ft).
Remove the plugs from the hose assemblies. Remove the caps from the ports in the fuel filter base.
Ensure that the hose assemblies are installed in the original positions. Failure