JAW GP-PULVERIZER 1796766 - Caterpillar

Connection Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A FT-2213 Strap (Group) 1
8S-4755 Bolt (1 inch by 14 by 1 1/2 inch) 4
6B-9194 Bolt (1 inch by 14 by 3 inch) 2
3K-5234 Hard Washer (6 mm by 49 mm) 18
Illustration 1 g00617969
Position the track under the machine.
Lower the machine on the track.
Remove Tooling (A).
Illustration 2 g00619611
Attach a chain to a wheel loader or a similar machine and to the end of track (8). Pull track (8) over the front idler.
Illustration 3 g00765553
Lift the end of the track in order to position the wood blocks under the grouser.
Pull the track until the bushings engage the sprocket segments on the final drive.
Start the machine and rotate the final drive backward in order to pull the track together.
Illustration 4 g00617971
Align the lower end of master link (7) with the upper end of the master link.
Illustration 5 g00617972
Position master shoe (6) on the master link and rear idler (4).
Apply 4C-5593 Anti-Seize Compound to bolts (5).
Install bolts (5).
Tighten bolts (5) to a torque of 650 70 N m (480 50 lb ft). Tighten the bolts by 1/3 turn more.
Illustration 6 g00617973
Tighten relief valve (2). Fill valve (3) with MPGM grease. Refer to Operation and Maintenance Manual, SEBU7247, "Track - Check/Adjust" for the correct Tight Track Adjustment procedure.
Adjust the track. Refer to Operation and Maintenance Manual, SEBU7247, "Track - Check/Adjust" for the correct track adjustment procedure.
Illustration 7 g00617976
Install track adjuster cover (1) and a new O-ring seal on the track roller frame.
Install the four bolts and the four washers in order to fasten the track adjuster cover.