JAW AS 3250807 - Caterpillar

Removal Procedure
Start By:
Install the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chock (Front and Rear) - Remove and Install".
Remove the cab rear cover. Refer to Disassembly and Assembly, "Cover (Cab Rear) - Remove and Install".
Release the air system pressure. Refer to Disassembly and Assembly, "Air Tanks (Brake) - Purge".
In order to prevent possible personal injury, release the air pressure from the air tank before disconnecting any components of the air system.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Put identification marks on all hose assemblies and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss and this helps to prevent contaminants from entering the system.
Illustration 1 g01597853
Disconnect stop light pressure switch (1). Disconnect harness assembly (2). Remove stop light pressure switch (1). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01597853
Install stop light pressure switch (1). Connect harness assembly (2). Tighten stop light pressure switch (1) to a torque of 30 3 N m (22 2 lb ft).
Charge the pressure in the air tank. Refer to Operation and Maintenance Manual, "Starting with an External Air Supply" for the correct procedure. End By:
Install the cab rear cover. Refer to Disassembly and Assembly, "Cover (Cab Rear) - Remove and Install".
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chocks (Front and Rear) - Remove and Install".