JET 2941722 - Caterpillar

of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption, service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant Extender (ELC) - Add
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Ether Starting Aid Cylinder - Replace
Film (Product Identification) - Clean
Fuel System - Prime
Generator - Dry
Generator Bearing - Lubricate
Generator Set - Test
Generator Set Alignment - Check
Daily
Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Generator Bearing Temperature - Test/Record
Generator Load - Check
Power Factor - Check
Initial 20 to 40 Service Hours
Belts - Inspect/Adjust/Replace
Every Week
Generator Lead (Flat Braided Cable) - Check
Voltage and Frequency - Check
Every 250 Service Hours
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil and Filter - Change
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Every 500 Service Hours
Battery Electrolyte Level - Check
Engine Oil Sample - Obtain
Fuel System Primary Filter (Water Separator) Element - Replace
Every 1000 Service Hours
Engine Protective Devices - Check
Every 2000 Service Hours
Generator - Inspect
Every 2000 Service Hours or 6 Months
Generator Lead (Round Cable) - Check
Generator Set Vibration - Inspect
Generator Set Vibration - Test/Record
Stator Lead - Check
Every 2000 Service Hours or 1 Year
Alternator - Inspect
Radiator - Clean
Every Year
Coolant Sample (Level 2) - Obtain
Generator Bearing - Inspect
Rotating Rectifier - Check
Varistor - Check
Varistor - Inspect
Every 4000 Service Hours or 2 Years
Coolant (DEAC) - Change
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine Crankcase Breather - Clean
Engine Mounts - Inspect
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 6000 Service Hours or 3 Years
Coolant (ELC) - Change
Overhaul
Generator Bearing - Replace
Overhaul Considerations