JOINT A 0675841 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A FT-2674 Vacuum Cap 1
B 138-7575 Link Bracket 2 Start By:
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Illustration 1 g01209599
Remove the cap from the hydraulic tank. Install Tooling (A) onto the hydraulic tank. Attach an air supply hose to Tooling (A). Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.
Illustration 2 g01285496
Disconnect hose assemblies (1) and (2).
Illustration 3 g01285497
Disconnect hose assemblies (3), (4), and (5).
Illustration 4 g01285500
Disconnect harness assembly (6). Remove bolts (7). Place bracket (8) and harness assembly (6) to the side.
Illustration 5 g01285577
Attach Tooling (B) and a suitable lifting device to swing motor (9). The weight of swing motor (9) is approximately 80 kg (175 lb). Remove bolts (10) and swing motor (9).