JOINT ASSEM. 7P2372 - Caterpillar

Disassembly Procedure (Main Relief Valve)
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1p-1853 Retaining Ring Pliers 1 Start By:
Remove the control manifold. Refer to Disassembly and Assembly, "Control Manifold - Remove". Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01231091
Remove bolts (3), cover (2), and O-ring seal (1).
Illustration 2 g01231092
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to