KEEPER 1C4527 - Caterpillar

All pictures are typical examples, but the procedures are the same for a 589.Start By:a. remove track roller frames (right or left) This operation was done with the right track roller frame removed. 1. Put wooden blocks (1) under the track. Put tooling (A) in position on the track and the edge of the track roller frame. This will be used to hold the track roller frame in position.2. Remove bottom guards. 3. Remove bolts (2) that hold hardbar end pin (3) in the track roller frame.
It will take several adjustments of tooling (B) to remove the end pin from the machine. Use tooling (A) if needed to remove any weight from the end pin.
4. Install tooling (B) and fasten a hoist to tooling (B). Remove hardbar end pin (3). 5. Remove cotter pins (4) that hold rear pins (5) in the frame saddles. Remove rear pins (5). It is not necessary to remove the front pins from the frame saddles. 6.