KICKOUT & POSITIONER GP 9R7639 - Caterpillar

1. Remove bolts (1) and plate (2). 2. Remove the fitting from the bottom of shaft (3) and use a hammer and brass punch to remove shaft (3) from the top of the link assemblies to disconnect steering cylinder rod (4). 3. Remove shims (5).4. Remove bolts (7) and plate (8). Remove the fitting from the bottom of the shaft and use a hammer and soft punch to remove the shaft from the top of link assembly (6).5. Remove link assembly (6) and the shims. 6. Remove the bolts and plate (10).7. Use a hammer and soft punch to remove shaft (11) from the top of link assembly (9).8. Remove link assembly (9) and the shims. 9. Use tool group (A) and a press to remove the bearings from the link assembly (9). 10. Remove the bushings and tube from the draft frame with tooling (B). 11. Remove the bushing from the hitch with tooling (C).Install Steering Links
1. Install bushing (1) in the hitch with tooling (A). 2. Pull upper bearing (2) into position in the draft frame with tooling (B) until it is even with the top surface of the frame. 3. Pull the tube and lower bearing (3) into position in the draft frame with tooling (C) until the bearing is even with the bottom surface of the frame. 4. Use tool group (D) and a press to install bearings (6) in link assembly (5).5. Put link assembly (5) and the shims in position on the hitch. Install shaft (7), plate (4) and the bolts. 6. Put link assembly (8) and the shims in position on the draft frame. 7. Install shaft (10), plate (9) and the bolts.8. Install the fitting in the bottom of shaft (10). 9. Put shims (13) as needed and steering cylinder rod (12) in position and install shaft (11). Install the plate and bolts to hold shaft (11) and install the fitting in the bottom of the shaft.10. Put clean grease in the fittings for the steering system.