KING POST GP 1342434 - Caterpillar

3. Disconnect fuel line (1) and hose assembly (2) from fuel priming pump (3). Cap and plug immediately.4. Remove four bolts (4) and the two retaining plates. Remove fuel priming pump (3) and the gasket from the engine. When installing the fuel priming pump, tighten four bolts (4) to a torque of 22 N m (16 lb ft). If the fuel priming pump is difficult to remove, rotate the crankshaft until the camshaft eccentric, which operates the fuel priming pump, is in a position which will free the lever on the fuel priming pump. When installing the fuel priming pump, make sure the camshaft eccentric is in the minimum lift position before the fuel priming pump is installed. Clean the face of the fuel priming pump and the cylinder block before installing the fuel priming pump. For installation of the fuel priming pump, reverse the removal steps. After the fuel priming pump has been installed it may be necessary to prime the fuel system. Refer to the Operation & Maintenance Manual, Form No. KEBU6902, for the correct procedure.