KIT 0033301 - Caterpillar

Start By:
Remove the center and rear bottom guards.
Illustration 1 g00867666
Align sprocket segment (1) with the idler on the right side of the machine. Remove nuts (2) and the bolts. Remove sprocket segment (1). This procedure will allow the roller frame to pivot when the front of the machine is raised.
Illustration 2 g01218846
Lift the blade assembly and install Tooling (D).
Illustration 3 g00867667
Use Tooling (C) to raise the machine. Place a 152 mm (6.0 inch) block under the left track. Lower the machine on the block until the weight is removed from the equalizer bar pins.
Illustration 4 g01218648
Illustration 5 g02355097
Use Tooling (B) and a suitable lifting device to support both ends of equalizer bar (3). The weight of equalizer bar (3) is approximately 102 kg (225 lb) to 259 kg (570 lb).
Illustration 6 g02355039
Remove bolts (4), guards (5), and pin (6). Repeat this step for the opposite side of the equalizer bar.
Illustration 7 g02355119
Disconnect hose assembly (7) and remove the fitting. Repeat this step for the opposite side.
Illustration 8 g02355122
Remove bolt (8), the washer, and the spacer.
Use Tooling (E) to remove center pin (9).
Illustration 9 g01310247
Use Tooling (C) to raise the machine for removal of the equalizer bar.
Illustration 10 g02355156
Illustration 11 g02355158
Use Tooling (B) to raise the left side of equalizer bar (3). Lower the right side of equalizer bar (3) until the right side of equalizer bar (3) will clear the frame.
Lower the left side and remove equalizer bar (3). Installation Procedure
Install equalizer bar (3) in the reverse order of removal.