KIT-BRAKE DISC 1122380 - Caterpillar

Illustration 16 g03731361
Route the harness from the electric swivel along the frame to the control panel. Refer to Illustration 16.
Illustration 17 g03731364
(E) Harness Assembly
Connect Harness Assembly (E) from the electric swivel to the control panel. Refer to Illustration 17.
Illustration 18 g03731365
(A) Bottom Guard Plate (B) Right Side Rail
Reinstall the Right Side Rail (B) to the lower frame. Reinstall the Bottom Guard Plate (A) to the rails. Refer to Illustration 1.MH3000 Zero Sensors
The sensor will have to be zeroed after the new electric swivel is installed. Use the following process to zero the sensor.
Illustration 19 g03732897
(N) F2 Diagnostic Display
Select F2 Diagnostic Display (N). Refer to Illustration 19.
Illustration 20 g03732900
(P) F2 Maintenance Display
Select F2 Maintenance Display (P). Refer to Illustration 20.
Illustration 21 g03732915
Select F2 - Pin Code Box will be displayed.
Illustration 22 g03732927
(R) Dial
Enter Maintenance Screen Code, 0000, by rotating Dial (R) to desired # and push enter in center of dial.
Select F2 for next.
Illustration 23 g03732929
(S) F3 Maintenance Display 2
Select F3 Maintenance Display 2 (S). Refer to Illustration 23.
Illustration 24 g03732939
(R) Dial
Rotate selector Dial (R) to select sensor number. Rotate Dial until display reads "1" and push the enter button in center of Selector Dial to select.
Illustration 25 g03732944
(R) Dial
Rotate Dial (R) until display reads "1". Refer to Illustration 25.
Illustration 26 g03732948
(R) Dial
Push enter button in center of Selector Dial (R) to select "1" – Zero Upper Lower Orientation. Refer to Illustration 26.Note: Section will change to green after selected
Illustration 27 g03732961
(R) Dial
Push enter button in center of selector Dial (R) to zero the sensor. When enter button is pushed, "Zeroed" will be flash displayed in front of the sensor. Refer to Illustration 27.When zeroing the sensor the machine has to be positioned properly:
Table 2
Sensor    Position    
1- Zero Upper Lower Calibration     Machine facing straight forward    
Upper and lower in line with each other