KIT-SEAL 1187917 - Caterpillar

TARGET="_parent">Boom and Stick Linkage - Lubricate
Every 100 Service Hours of Continuous Hammer Use
Hydraulic System Oil Filter (Case Drain) - Replace
Hydraulic System Oil Filter (Pilot) - Replace
Initial 250 Service Hours
Engine Valve Lash - Check
Final Drive Oil - Change
Hydraulic System Oil Filter (Case Drain) - Replace
Hydraulic System Oil Filter (Pilot) - Replace
Hydraulic System Oil Filter (Return) - Replace
Swing Drive Oil - Change
Every 250 Service Hours
Cooling System Coolant Sample (Level 1) - Obtain
Engine Oil Sample - Obtain
Final Drive Oil Sample - Obtain
Every 250 Service Hours for Machines Used in Severe Applications
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Every 250 Service Hours or Monthly
Belts - Inspect/Adjust/Replace
Condenser (Refrigerant) - Clean
Final Drive Oil Level - Check
Swing Bearing - Lubricate
Swing Drive Oil Level - Check
Every 250 Service Hours of Partial Hammer Use (50% of Service Hours)
Hydraulic System Oil Filter (Case Drain) - Replace
Hydraulic System Oil Filter (Pilot) - Replace
Every 250 Service Hours of Continuous Hammer Use
Hydraulic System Oil Filter (Return) - Replace
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Cooling System Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Hydraulic System Oil Sample - Obtain
Swing Drive Oil Sample - Obtain
Every 500 Service Hours or 3 Months
Boom and Stick Linkage - Lubricate
Engine Crankcase Breather - Clean
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel System Third Filter - Replace
Fuel Tank Cap and Strainer - Clean
Every 600 Service Hours of Continuous Hammer Use
Hydraulic System Oil - Change
Every 1000 Service Hours or 6 Months
Battery - Clean
Battery Hold-Down - Tighten
Engine Valve Lash - Check
Final Drive Oil Level - Check
Hydraulic System Oil Filter (Case Drain) - Replace
Hydraulic System Oil Filter (Pilot) - Replace
Rollover Protective Structure (ROPS) - Inspect
Swing Drive Oil - Change
Every 1000 Service Hours of Partial Hammer Use (50% of Service Hours)
Hydraulic System Oil - Change
Hydraulic System Oil Filter (Return) - Replace
Every 2000 Service Hours or 1 Year
Final Drive Oil - Change
Hydraulic System Oil Filter (Return) - Replace
Hydraulic Tank Screen - Clean
Receiver Dryer (Refrigerant) - Replace
Swing Gear - Lubricate
Every Year
Cooling System Coolant Sample (Level 2) - Obtain
Every 3 Years After Date of Installation or Every 5 Years After Date of Manufacture
Seat Belt - Replace
Every 6000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add
Hydraulic System Oil - Change
Every 12 000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change