KIT-CYLINDER HEAD GASKET 1210780 - Caterpillar

Basic Operation
This section describes the various messages from Trimble Mincom Aquila Caterpillar (TMAC) that allow communication between Fleet onboard on the truck with Fleet onboard or Terrain on the loading machine.Phase 1
Upon the entrance of a truck into a loading face waypoint, the status changes to a "waiting" state. Fleet onboard on the truck sends a load request message to Fleet onboard on the loading machine that indicates the following information: the material that was loaded on the truck and the operating state of the truck. The loading machine responds with an acknowledgment message ("MW_ACK") that indicates the position of the loading machine.Phase 2
A truck that enters a shovel waypoint will change status to a "loading" state. Fleet onboard on the truck sends another load request message to the loading machine that indicates that the truck is in a "loading" state. The loading machine responds with another "MW_ACK" message that indicates the position of the loading machine. Fleet onboard on the truck verifies that the truck is at the correct loading machine.Phase 3
The truck will send a VIMS dipper report to the loading machine and to the office under the following conditions: a truck that is equipped with the VIMS and first dipper load that is received.When a loading machine that is equipped with Terrain detects the first dipper load that has been placed in the truck, Terrain on the loading machine sends a dipper message to the office. This dipper message tells the office the material that is in the truck. The office then triggers an assignment.Note: When loading is complete, if Terrain determines that the material in the truck has changed from the material that was indicated in the first dipper message, the onboard system will assess again the best destination for the truck. Then, the office will issue an updated assignment for the truck.Phase 4
"Scenario A"
When loading is complete, the machine operator on the loading machine presses the "send truck" button to send a truck sent message to the truck. The truck sent message indicates that loading is complete to the truck. Then, the truck sends a load request message to the loader that indicates that the truck has changed to the "traveling" state. The loading machine sends a load report to the office that specifies the material that was loaded into the truck with the truck ID.If the truck has VIMS, and when loading is complete, the truck sends a VIMS