KIT-WATER PUMP REBUILD 1279885 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 7M-3975 Valve Guide Driver 1 Start By:
Remove the inlet valves and the exhaust valves. Refer to Disassembly and Assembly, "Inlet and Exhaust Valves - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01133624
Remove valve stem seal (3) from inlet valve guide (2). Note: The valve stem seal is not installed on exhaust valve guide (1).
Turn the cylinder head upside-down. Use Tooling (A) and a hammer to remove the valve guides from the cylinder head. Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 7M-3975 Valve Guide Driver 1
B 5P-1729 Valve Guide Bushing 1 Note: If you replace the valve guides, you must replace the valve seats with new valve seats.Note: Inspect the valve guides. Do not use valve guides with obvious damage or with excessive wear. Check available specifications. Remove valve guides that are loose or damaged. Replace the valve guides with new components, if necessary. Correct any condition that could cause the original damage or wear.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Use new valve guides for assembly.
Illustration 2 g01133624
Coat the outside of the valve guide with clean engine oil prior to installation.
Use Tooling (A) and Tooling (B) to install exhaust valve guide (1) and inlet valve guide (2) in the cylinder head.
Install new valve stem seal (3) on inlet valve guide (2). Note: Valve stem seals are not installed on exhaust valve guide (1).End By:
Install the inlet valves and the exhaust valves. Refer to Disassembly and Assembly, "Inlet and Exhaust Valves - Remove and Install".