KIT-GASKET 1358812 - Caterpillar

Illustration 1 g00996470
(1) Clamp boltUse the following bolt tightening sequence in order to tighten the clamp bolts.
Place the clamp assembly so that the clamp assembly is snug against the tube.
Tighten the clamp assembly to the elbow.Torque ... 47 9 N m (35 7 lb ft)
Tighten the clamp assembly to the tube.Torque ... 47 9 N m (35 7 lb ft) (2) Stud
Apply 154-9731 Thread Lock Compound to the last 10.2 1.5 mm (.40 .06 inch) of the thread at the base end of the stud.
Tighten the filter element studs in the oil filter bases to the following torque:Torque ... 80 14 N m (60 10 lb ft) (3) Oil filter
Put clean engine oil on the oil filter seals.
Put oil filters (3) in position and tighten the oil filters until the seals make contact with the oil filter bases.
Rotate the filters for an additional 360 degrees. (4) 7G-6713 Spring for the oil filter bypass valves Length under test force ... 57.2 mm (2.25 inch) Test force ... 109 5 N (24.5 1.1 lb) Free length after test ... 99.7 mm (3.93 inch) Outside diameter ... 21.23 mm (0.836 inch) Color code (stripes) ... one light blue stripe (5) Oil filter bypass valve The oil filter bypass valves must open at the following pressure difference: ... 230 20 kPa (33 3 psi)