KIT-CARRIER 1368651 - Caterpillar

Storage Of Items
1. Long-term storage of items is limited to 12 months. As a rule, items stored in excess of this must be overhauled. All seals must be replaced and all parts must be checked for rust or other defects.2. Store items in conditions that prevent damage to mating surfaces.3. Put items into service only after checking for oil leakage from seals and other likely trouble during operation if storage has been for a period of 6 to 12 months.4. Rust-preventive treatment must be given to all items before storing.5. Select an appropriate place to store items, such as a dry, clean place that is not exposed to the weather or direct sunlight. Note that items will require overhauling much earlier if stored in unsatisfactory circumstances.Cleaning
1. Remove dust, dirt and moisture with a clean cloth. Take necessary steps to remove rust if items gather rust.2. Use cleaning agent (petroleum solvent) to completely remove grease.3. Use methyl alcohol or fingerprint remover (NP-0, JIS Z1804 or equivalent) to remove finger marks and make surface completely clean.4. Clean by brushing or wiping with a cloth.5. Do not attempt to clean coated parts, parts using rubber or other materials or parts affectred by solvents.Internal rust prevention
Fill the internal section with volatile rust preventive agent (NP-20-1 Z1806 class 1 or equivalent) and close with polyethylene plugs to prevent rust due to sweating.External rust prevention
Protect noncoated parts from rust as follows:1. Apply a coat of rust preventive grease (NP-19, JIS Z1801 class 4 or equivalent) by brushing on mating surfaces. Give an even coat of rust-preventive oil [MIL-L-644 (P-9) or equivalent] to other parts.2. Cover finished items with vinyl sheet or VPI paper after coating with rust preventive compound. Store items in a well-ventilated place. Tape up covers if necessary.3. Remove the cover and wipe off rust preventive grease with a cloth. Use a cleaning agent unlikely to affect rubber or similar materials for removal if necessary.Storage Of Parts
Storage of metal parts
1. Rust prevention method Clean parts as shown in above and apply a coat of rust-preventive grease (NP-19, JIS Z1801 class 4 or equivalent) by brushing. Cover the finished parts with vinyl sheet or VPI paper after they are coated with rust preventive compound. Tape up covers if necessary.2. Storage method Place antirust treated parts on shelves individually for storage. Never place parts on top of each other for storage.Storage of rubber parts
1. Storage method Store O-rings and other rubber parts in a place free from exposure to direct sunlight or high temperature [40°C (104°F) or more] to prevent deterioration.2. Storage period The storage period is limited to a maximum of 12 months. Do not use parts stored in excess of 12 months.