KIT-SUN GEAR 1478499 - Caterpillar

Open the Parameter Control List
Perform the following in order to open the Parameter Control list:
Click on "Open" in the "PTE".Note: An "Open" dialog will be displayed. Refer to Illustration 29.
Illustration 29 g01336395
Use the dialog to navigate to the disk location where the *.pcl file to be modified is located.
Select the file.
Click "Open".Note: The "PTE" will read in the *.pcl file. The "PTE" will recreate the Design window objects. The screen should look similar to Illustration 30.Delete Parameters from the 36XX Engine Cntrl to PL1000E Interface Translation
Perform the following steps in order to delete parameters from the 36XX Engine Cntrl to the PL1000E interface translation.
Select the "Translation Object" in the "Design" window.
View the parameters in the "Properties" window.
Click on the name of the parameter that is to removed.Note: As an example, the "Atmospheric Pressure" parameter has been chosen to be removed.
Press the "delete" key that is on the keyboard of the computer.Note: The parameter will be removed from the "Translation Parameter List".Add Parameters to the 36XX Engine Cntrl to PL1000E Interface Translation
Perform the following in order to add parameters from the 36XX Engine Cntrl to the PL1000E interface translation:
Select the "Translation Object" in the "Design" window.
View the parameters in the "Properties Window".
Click on "Click to Add" in the "Parameter List".
Select the desired parameters that are to be added to the translation.Note: For this example, add the "Diagnostic Clock".Modify the Request Rate for the New Parameter(s)
The request rates should be carefully considered. More dynamic parameters should be defined with smaller request rates and less dynamic parameters should be defined with larger request rates. Since the diagnostic clock will not change with extreme frequency, Request Rate of 100000 milliseconds has been selected.The "PTE Design" window should now look similar to Illustration 30.
Illustration 30 g01709154
Save the Modified *.pcl File To Disk
Perform the following in order to replace the existing *.pcl file to a disk:
Click the "Save" button.Note: The PTE will write the new data directly into the previously saved file.Perform the following steps in order to retain the previously configured file as a history.
Select the "Save As" button just below the Save button.Note: This will open a "Save As" dialog box.
Define a new file name and location for the modified file.Note: The *.pcl file has been successfully modified. It is always a good practice to keep a copy of the file that was previously working correctly, until the new file can be tested and verified in the system.
Install the *.pcl file into the PL1000E file system.Note: See "Installation of PCL File to PL1000E" Section of this document.Installation of PCL File to PL1000E
Installation of a *.pcl file is necessary for the PL1000E Communication ECM to begin making translated data available on the target data link. The example in this manual has focused on the creation of a *.pcl file for translation of CDL parameters to Modbus. Discussions will continue to reference this same example.PCL files are installed on the PL1000E using a standard FTP connection. An FTP connection may be established through either the facility