KIT-GASKET 1488269 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1U-6684     Piston Ring Compressor     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Refer to Disassembly and Assembly, "Connecting Rod Bearings - Install" for the inspection procedure of the connecting rod bearings and the crankshaft connecting rod journals.
Put clean engine oil on the following components:
Crankshaft journals
Inside of the cylinder bores
Piston rings
Connecting rod bearings
Rotate the crankshaft until the bearing journals are at the bottom center. The bearing journals that are at the bottom center are for the piston installation.
Illustration 1 g00829711
Illustration 2 g00829724
Put the piston and connecting rod in the cylinder bore. Align the identification marks on the top of the piston to the front of the cylinder block. Align identification marks (2) on the side of the connecting rod to the right side of the cylinder block. Put Tooling (A) in position on the cylinder block and compress the piston rings.Note: Move the piston rings on the pistons until the ring openings are separated by approximately 90 degrees. Refer to Disassembly and Assembly, "Pistons and Connecting Rods - Assemble".Note: Use tape or rubber tubing on the connecting rod bolts to protect the crankshaft journals.
Align the piston and the connecting rod with the crankshaft. Use a soft faced hammer (1) to tap the piston into the cylinder bore until Tooling (A) comes off the piston.Note: Ensure that Tooling (A) is installed correctly in order to allow the piston and the connecting rod to easily slip into the cylinder block.
Illustration 3 g00829733
Before the connecting rod contacts the crankshaft, install the upper half of rod bearing (4) in the respective connecting rod (3). Make sure that the bearing tab properly engages with the slot in the connecting rod.
Place clean engine oil on the surface of the upper half of the connecting rod bearing. Guide the connecting rod into position on the crankshaft.
Install the lower half of connecting rod bearing (5) in the correspondingly marked connecting rod cap (6). Put clean engine oil on the surface of the lower half of the connecting rod bearing and on the connecting rod bolts.
Install connecting rod cap (6) and connecting rod nuts (7) .For 3011C Engines, tighten the nuts for the connecting rod cap to a torque of 32 N m (24 lb ft).For 3013C Engines and 3024C Engines, tighten the nuts for the connecting rod cap to a torque of 52 N m (38 lb ft).
Repeat Steps 1 through 8 for the remainder of the pistons and connecting rods.
Rotate the crankshaft in order to ensure that no binding occurs.End By:
Install the oil suction screen. Refer to Disassembly and Assembly, "Crankshaft - Install".
Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Install the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Install".