KIT-SEAL 1514965 - Caterpillar

Range Selector
(F) FORWARD DIRECTION(N) NEUTRAL(R) REVERSE DIRECTION Rotate Range Selector lever to desired speed.Column Lock
Column Locked position. To unlock column, turn key clockwise. Remove key.Column Release
While holding steering wheel, pull lever out to release steering column, and move column to desired position. Release lever to lock column in position.Parking Brake
Pull out on lever to engage parking brake. Push in to release parking brake.Bucket Tilt Control
(D) DUMP(H) HOLD(T) TILT BACKBucket Lift Control
(F) FLOAT(L) LOWER(H) HOLD(R) RAISEVCTC - (Variable Capacity Torque Converter)
MIN - Minimum torque to drive wheels, and maximum horsepower to bucket hydraulics. MAX - Maximum usable torque to drive wheels, and limited horsepower to bucket hydraulics.VCTC Override
Move the VCTC switch forward to override the VCTC control lever setting and provide maximum torque to drive wheels. Move switch to the rear to return VCTC to the control lever setting. Maximum torque is available when the full torque indicator is on.Brake Pedals
RIGHT - Depress to reduce machine ground speed. LEFT - Depress to reduce machine ground speed, neutralize the transmission and bring machine to stop.Accelerator
Depress to increase engine speed. Release to decrease engine speed.Horn Switch
Depress to cause horn to sound.Main Disconnect Switch
This switch is located in the engine compartment, left side of machine. Turn switch to OFF, when servicing any part of electrical system. (1) OFF(2) ON
Do not turn switch to OFF when engine is running.
Power Switch
OFF - Power to electrical system is disconnected. ON - Power is supplied to the electrical system. TEST PANEL LIGHTS - In this position all indicator lights, except Full Torque indicator, should come ON to indicate they are not burned out. With the Power switch ON and the Engine - Start switch not moved, the Prestart Fluid Level indicators should come ON if it is necessary to add fluids to the engine crankcase, hydraulic oil tank or the fuel tank.Engine - Start Switch
HEAT - Move switch to LEFT to heat the glow plugs to aid in starting.START - Move switch to RIGHT to START to engage starter-motor. Glow plugs will also be heated in START position.Engine - Stop Switch
Depress and hold in on button until engine stops. Turn power switch off.Windshield Wiper-Washer Switch
Rotate switch clockwise to turn wiper ON. Push in on switch to activate washer.Tail - Panel Light Switch
(1) ON(2) OFFHeadlight Switch
(1) ON(2) OFFFloodlight Switch
(1) ON(2) OFFAuxiliary Floodlight Switch
(1) ON(2) OFFFan Speed Control
Clockwise - Heater Fan Speed.(O) OFF, (L) LOW(M) MEDIUM, (H) HIGH Counterclockwise - Air Conditioner Fan Speed.(L) LOW, (M) MEDIUM, (H) HIGH Pressurizing System must be run at all times to keep dust from entering cab when doors and windows are closed.Heater Temperature Control
(O) OFF, (W) WARMAdjust switch between OFF and WARM to control amount of heat.Air Conditioner Control
(O) OFF, (C) COOLAdjust switch between OFF and COOL to control amount of cooling.Floor Heater
(1) OFF (2) ONAdjust switch between OFF and ON to control amount of heat.Dome Light Switch
(1) OFF(2) ON