KIT-CARRIER 1536090 - Caterpillar

Procedure To Install Replacement Meter Kit And Power Generating Unit
1. Install the replacement meter kit in the desired location.2. Install the power generating unit with its locknut in the 5/8"-18 threaded hole in the flywheel housing. Screw the unit in until the tip on the unit contacts a tooth on the flywheel then back the unit out one-half turn. This will provide the correct clearance between the power generating unit and the flywheel.3. Tighten the locknut on the power generating unit to a torque of 45 7 N m (33 5 lb ft).4. Measure the amount of 18 gauge, two conductor wire needed to complete the electrical circuit between the Sure-Seal connector on the meter wire assembly and the Sure-Seal connector on the power generating unit. Use the 6V3000 Sure-Seal Repair Kit to install the correct Sure-Seal connectors on each end of the 18 gauge wire.