KIT-SEAL 1949632 - Caterpillar

Image1.7.1
14. Remove the six M12 bolts (13) that secure the mount to the front of the engine and save bolts. Remove front support as. by sliding it towards the radiator until mount plate clears the pulley mandrel. The front support as will not be reused.
15. Install new 349-7230 Support As-Engine and reuse six M12 bolts (13) to secure mount to front of the engine. Tighten the bolts to a torque of 100 +/- 20 Nm.
Image1.8.1
16. Lower engine and Secure mount with two 8T-4183 Bolts (14), two 5P-1076 Washers (15), four 7X-2570 Bolts (16), four 198-4781 Washers (17), four 415-2830 Spacers (18), and four 300-0024 Nuts (19). Verify surface is clean so spacers will sit flat against underside of mount. Tighten the M12 bolts to a torque of 100 +/- 20 Nm. Tighten the M20 bolts to a torque of 460 +/- 60 Nm. Use 16? extension to clear fenders for the torque wrench.
Image1.9.1
Image1.9.2
17. Reinstall balancer, pulleys, and belts. Refer to KENR8882-01 for belt, pulley, and damper installation procedure.
18. Reassemble rest of parts in reverse order of disassembly instructions.
19. Remove the transmission mount bolts, washers, and square nuts (both sides). These bolts, washers, and nuts will not be reused.
20. Assemble four 7X-2568 Bolts, four 198-4781 Washers, four 415-2830 Spacers, and four 300-0024 Nuts. Verify that the surface is clean