KIT-SEAL 2024086 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tooling Part Number Description Qty
A 8S-2264 Puller 1
9S-9155 Spacer 1
- Bolt (3/8 inch - 24 NF x 3 1/4 inch) 2
- Flat Washer 2
B 1P-0510 Driver 1
C 1P-2321 Combination Puller 1 Start By:
Remove the timing gear cover. Refer to Disassembly and Assembly, "Timing Gear Cover - Remove" for the engine that is being serviced.
Illustration 1 g00989118
Turn the crankshaft until No. 1 piston is at TOP DEAD CENTER position and the "C" mark on the crankshaft gear is in alignment with the "C" mark on the camshaft gear, as shown.
Illustration 2 g00989119
Remove bolt (2) and the washer from magneto drive gear (1).
Illustration 3 g00989122
Install Tooling (A) on magneto drive gear (1). Use Tooling (A) in order to remove magneto drive gear (1) from the magneto drive shaft.
Illustration 4 g00989123
Remove two bolts (3) and the plate.
Remove idler gear (2).
Remove four bolts (4) from the camshaft gear.
Illustration 5 g00989128
Use Tooling (B) in order to remove the bearing from idler gear (2).
Illustration 6 g00989130
Install Tooling (C) on camshaft gear (5).
Use Tooling (C) in order to carefully remove camshaft gear (5).