KIT-GASKET 2169612 - Caterpillar

Illustration 1 g01106378
Installation diagram for 12, 24, 30, and 32 volt systems
Illustration 2 g01106391
Location for atomizer and temperature switch (1) Ether cylinder (2) Clamp The clamp should be located 178 mm (7.0 inch) above the mounting holes. (3) Ether valve When the cylinder (1) is installed and the control panel switch (5) is pressed for three seconds, the ether valve supplies 2.25 cc (0.137 cu in) of ether.Note: The ether valve should be mounted as close as possible to the engine inlet manifold. The ether valve should not be mounted on the engine. The ether valve should not be exposed to temperatures higher than the following temperature of 93 °C (200 °F). Install the ether valve so the cylinder (1) can be installed in 20 degrees from vertical position A. See Illustration 1. (4) Temperature switchThe temperature switch will not allow the starting fluid to reach the atomizer if the engine temperature is above the following temperature. ... 38 °C (100 °F)Remove the pipe plug (3/8 inch) from the left rear corner of the cylinder head and install the temperature switch. Tighten the temperature switch to the following torque. ... 40 5 N m (30 4 lb ft) (5) Starting aid switchInstall the switch close to the operator's starting station. The switch requires a clearance hole for the thread (5/8 inch). The hole must be located behind the control panel. The distance ... 38 mm (1.50 inch) (6) Ether valve connector (7) Steel tubeInstall the steel tubing between the valve and the atomizer. Use the flexible coupling tube assembly between the two lines as a flexible connection. The use of any additional length of tubing is not recommended. No electric wires should be clamped to the ether lines. (8) Location of the atomizerRemove the pipe plug (1/4 inch) out of the air inlet and install the atomizer. Before the atomizer is tightened, turn the identification mark. The mark should face the front or the rear of the engine. (9) Electrical wire (10) Inlet manifold