KIT-CONTROL 2193302 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the implement hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Release hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release" in this manual.
Illustration 1 g00373012
This view is beneath the platform.
Remove seven bolts (1) and the washers that hold access plate (2) in place. Remove the access plate from the platform.
Illustration 2 g00373032
This view is beneath the platform.
Disconnect electrical wiring harness (3) from the neutral switch.
Disconnect rod (4) from the selector valve.
Illustration 3 g00373072
This view is beneath the platform.
Put identification marks on hose assemblies (5) that are connected to the selector valve for installation purposes. Disconnect the hose assemblies from the selector valve. Put plugs in the ends of the hose assemblies in order to keep dirt and debris out of the hydraulic system. Put caps on the hydraulic activation valve. Caps prevent oil loss. Caps keep dirt and debris out of the hydraulic activation valve.
Illustration 4 g00373092
This view is beneath the platform.
Remove two bolts (6) and the washers that hold the selector valve in place. Remove the selector valve.