KIT-SEAL 2281778 - Caterpillar

Glass beads are commonly used to clean carbon from pistons, valves, and turbochargers. But, it is important to use the correct size of glass bead for the job. If the beads are too small, it is difficult to clean the part. If the beads are too large, it is possible for some parts to be damaged, while others will not get clean.
A Size "10" glass bead has given the desired result when used to clean engine pistons and valves, and turbochargers. The Size "10" bead will clean the part without damage if it is used with care.
Some parts, such as valve stems and turbocharger shafts, must be covered to prevent damage.
When pistons are cleaned, the ring grooves must be checked for burrs and carbon. Burrs can be removed with a small file and smaller beads can be used to clean the remainder of the carbon out of the groove.
Recommendations for a glass bead size of 50-100 microns (.0020-.0039") are given in some "Guidelines For Reusable Parts." The larger Size "10" bead, 88-149 microns (.0035-.0059"), will give better results. Size "9" beads, 125-177 microns (.0049-.0070") through Size "11", 75-125 microns (.0029-.0049") are also acceptable for this application.
A bead larger than 230 microns (.0091") must never be used for engine pistons and valves, and turbochargers.
The chart which follows gives the acceptable glass bead sizes used to clean different parts, part numbers of the glass beads and suppliers.