KIT-SEAL 2292626 - Caterpillar

"Lower Gears Engine RPM Limit"
This parameter causes the engine to accelerate at a slower rate when the rpm limit is exceeded under normal driving conditions. This can encourage the driver to shift to the next highest gear.This parameter should remain at the default value if the vehicle is equipped with an automatic transmission.
Table 1
Default     Minimum     Maximum    
TEL rpm     1100 rpm     TEL rpm    "Lower Gears Turn Off Speed"
This parameter is the vehicle speed which turns off the "Lower Gears Engine RPM Limit". This must be matched with the "Lower Gears Engine RPM Limit" to the specific drive train for best performance.This parameter should remain at the default value if the vehicle is equipped with an automatic transmission.
Table 2
Default     Minimum     Maximum    
5 km/h (3 mph)    
5 km/h (3 mph)    
48 km/h (30 mph)    "Intermediate Gears Engine RPM Limit"
This parameter is similar to the "Lower Gears Engine RPM Limit". The engine will accelerate at a slower rate when this limit is exceeded under normal driving conditions. This parameter is typically programmed to a slightly higher rpm than the "Lower Gears Engine RPM Limit".This parameter should remain at the default value if the vehicle is equipped with an automatic transmission.
Table 3
Default     Minimum     Maximum    
TEL rpm     1000 rpm     TEL rpm    "Intermediate Gears Turn Off Speed"
This parameter is similar to the "Lower Gears Turn Off Speed". This parameter is typically programmed to a slightly higher vehicle speed than the "Lower Gears Turn Off Speed".This parameter should remain at the default value if the vehicle is equipped with an automatic transmission.
Table 4
Default     Minimum     Maximum    
8 km/h (5 mph)    
8 km/h (5 mph)    
80 km/h (50 mph)    "Gear Down Protection RPM Limit"
This parameter is the engine rpm limit when the vehicle speed is above the "Gear Down Protection Turn On Speed". This is a hard limit. The Engine Control Module (ECM) will not allow fuel to the engine above this limit. This parameter is used to encourage the driver to shift into overdrive or top gear.This parameter should remain at the default value if the vehicle is equipped with an automatic transmission.
Table 5
Default     Minimum     Maximum    
TEL rpm     1300 rpm     TEL rpm    "Gear Down Protection Turn On Speed"
This parameter is the vehicle speed when the "Gear Down Protection RPM Limit" is turned on. This must be matched to the specific drive train for best performance. The engine rpm is limited by the "Gear Down Protection RPM Limit" when the vehicle speed is above the value of this parameter.
Table 6
Default     Minimum     Maximum    
121 km/h (75 mph)    
48 km/h (30 mph)    
204 km/h (127 mph)    "Low Idle Engine RPM"
This parameter is the minimum engine rpm.
Table 7
Default     Minimum     Maximum    
600 rpm     600 rpm     750 rpm