KIT-SEAL 2295549 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0510 Driver Group 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01007193
Coat the lip seals for bracket (16) with clean engine oil.
Use Tooling (A) in order to install inner lip seal (18) and outer lip seal (17) into bracket (16). Note: If the bearings in bracket (16) are damaged, the bracket must be replaced. The bearings are nonserviceable separately.
Illustration 2 g01007192
Install the O-ring seal onto casing (14). Install casing (14) and sleeves (15) onto bracket (16).
Illustration 3 g01007191
Install idler gear (12) and drive shaft (13) into casing (14).
Illustration 4 g01007155Note: If the bearings in plate (9) are damaged, the plate must be replaced. The bearings are nonserviceable separately.
Install the O-ring seal into the side of the plate that is opposite of gasket (11). Install plate (9). Install gasket (11).
Illustration 5 g01007154Note: Before you install check valve (10) in head (8), make sure that the spring on the check valve is oriented toward the inside.
Install check valve (10) into head (8).
Illustration 6 g01007146
Install head (8) onto plate (9).
Install bolts (7).
Illustration 7 g01007139
Personal injury can result from parts and/or covers under spring pressure.Spring force will be released when covers are removed.Be prepared to hold spring loaded covers as the bolts are loosened.
Install the following items into the bracket: cap (6), washer (5), valve spring (4) and poppet valve (3).
Illustration 8 g01007133
Install O-ring seal (1).
Install drive coupling (2) onto the drive shaft. End By:
Install the fuel transfer pump. Refer to Disassembly and Assembly, "Fuel Tranfer Pump - Install".