KIT-SEAL 2297189 - Caterpillar

System configuration parameters are parameters that affect emissions, power of the engine, and other features. The parameters are programmed at the factory. In most cases, the parameters do not need to be changed. You must reprogram the system configuration parameters if the Electronic Control Module (ECM) is replaced and/or if you reprogram the engine rating. You do not need to reprogram the system configuration parameters if you replace the personality module. Proper values for these parameters are available on the Caterpillar Electronic Technician (ET). Certain system configuration parameters are also stamped on the engine information plate.The following functions will be performed with an engine that has EMCP II:
Automatic Start/Stop
Air shutoff
CooldownNote: Changing the parameters that are protected by factory passwords may cause your Caterpillar warranty to be voided.
Engine Serial Number
Program the engine serial number to match the engine information plate. The serial number is not programmed on a new ECM.Rated Fuel Position
This parameter is used to set engine power. A factory password is required to change this setting.
Table 1
Minimum     Default     Maximum    
Minimum Rack     Engine Dependent     Engine Dependent    Acceleration Delay
When the engine is started, the ECM will limit the engine to low idle. The ECM will no longer limit the engine rpm when the following conditions exist:
The engine oil pressure is above 70 kPa (10 psi).
The acceleration delay is reached.Programming this parameter to 0 will disable this function.Note: If the engine is configured to operate in direct fuel control mode, this parameter is disabled.
Table 2
Minimum     Default     Maximum    
0 seconds     0 seconds     60 seconds    Acceleration Ramp Rate
The acceleration ramp rate is the maximum ramp rate of the desired engine rpm. The desired engine rpm will be set to low idle until the engine rpm reaches 400. When the engine rpm becomes greater than 400 rpm, desired engine rpm will start increasing until the required desired engine rpm is reached.Note: If the engine is configured to operate in "Direct Fuel Control Mode", this parameter is disabled.
Table 3
Minimum rpm per second     Default rpm per second     Maximum rpm per second    
1 rpm/sec     250 rpm/sec     750 rpm/sec    Low Idle
The parameter defines the low idle rpm.Note: If the engine is configured to operate in direct fuel control mode, this parameter is disabled.
Table 4
Minimum     Default     Maximum    
810 rpm     1000 rpm     1000 rpm    Cooldown Speed
This parameter defines the engine rpm during the cooldown period.
Table 5
Minimum     Default     Maximum    
810 rpm     1000 rpm     1800 rpm    Cooldown Period
This parameter defines the duration of engine operation at the cooldown speed. Programming this parameter to 0 will disable this function.Note: Program this parameter to 0 if EMCP II is connected to this system. Problems may result if both controls try to perform this function.
Table 6
Minimum     Default     Maximum    
0 minutes     0 minutes     30 minutes    Prelube Time
The