KIT-SEAL 2315820 - Caterpillar

ACTION REQUIRED
Refer to the attached Rework Procedure.
OWNER NOTIFICATION
Owners in the following countries will receive the attached Owner Notification:
US
Canada
SERVICE CLAIM ALLOWANCES
Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
100% 100% 0% 0% 0% 0%
This is a 1.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
EXAMPLE COPY OF OWNER NOTIFICATION
XYZ Corporation
3240 Arrow Drive
Anywhere, YZ 99999
PRIORITY - PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND REWORKING THE FUSE PANEL HARNESS ON CERTAIN D6T TRACK-TYPE TRACTORS
MODELS INVOLVED - D6T Track-Type Tractor
Dear Cat Product Owner:
The 437-8293 Fuse Panel Harness Assembly needs to be inspected and adjusted on the products listed below. The existing harness assembly can interfere with the main relay studs and can wear through. You will not be charged for the service performed.
Contact your local Cat dealer immediately to schedule this service. The dealer will advise you of the time required to complete this service.
If you are no longer the owner of this product(s), please contact your local Cat dealer so that our records can be updated. Please refer the dealer to their Service Letter dated 13Jun2014 when scheduling this service.
We regret the inconvenience this may cause you, but urge you to have this service performed as soon as possible to prevent unscheduled downtime.
Caterpillar Inc.
Identification #(s)
Attached to 13Jun2014 Service Letter
Rework Procedure
1. Open the front access door to the fuse panel compartment located on the left-hand fender. (Reference Image 1.1.1) Review the clearance between the lowest inboard pigtail (orange connector) of the 437-8293 Fuse Panel Harness Assembly to the 241-8368 Main Power Relay Studs. If there is no clearance between the wires and the studs, proceed to Step 2 to adjust. If adequate clearance is present to prevent harness failure, close the door and finish. (Reference Image 1.1.2 & 1.1.3)
Image1.1.1
Image1.1.2
Image1.1.3
2. If interference is present, remove the 380-7789 Front Battery Box Cover and set cover and hardware aside. Cut the quantity 4 7K-1181 Tie Straps securing the fuse panel harness. (Reference Image 1.2.1) Inspect the harness assembly for excess wear and repair as needed. Adjust the harness up and away from the relay to provide clearance using the new 7K-1181 Tie Straps. Re-install cover assembly.
Image1.2.1