KIT-ENGINE GASKET 2331132 - Caterpillar

Calibration Procedure
In order to calibrate the blade slope sensor, complete the following steps:
Illustration 1 g01694953
From the "Setup Menu - Configuration" dialog, press the arrow keys in order to highlight "Calibrate Sensors".Refer to Illustration 1.
Press the "OK" key.The AccuGrade System allows two ways to calibrate the blade slope sensor. Choose one of the following options:"Blade Slope Sensor (Turnaround)" - This option allows calibration of the sensor without the use of a level. The machine will need to be rotated for this procedure.Proceed to Step 8."Blade Slope Sensor" - This option allows calibration of the sensor with the use of a digital level.Proceed to Step 3.
Illustration 2 g01352439
Use the arrow keys in order to highlight "Blade Slope Sensor". Press the "OK" key.A screen that is similar to Illustration 3 appears.
Illustration 3 g01450668
Raise the bowl so that there is enough room in order to use a level under the edge of the blade.Note: .Do Not Move The Bowl.
Place blocks under the bowl before checking in order to ensure that the bowl is level.
Use the digital level in order to measure the slope of the cutting edge of the bowl. Enter this value into the "Measured blade slope" field of the "Calibrate Sensor" dialog. Use the "Swap Slope" soft key in order to set the correct direction of slope.
Press the "Calibrate" soft key.The blade slope sensor is calibrated to "0.0" percent. The "Calibrate Sensor" dialog is closed. The "Calibrate Sensors" dialog appears.Note: The machine must be on a level surface and the blade must be located in the operating position.The "Calibrate Sensor" dialog shows the current slope reading from the sensor.Proceed to Step 14.
Use the arrow keys in order to select "Blade Slope Sensor (Turnaround)".
Press the "OK" key.
Park the machine on a level surface. Place a mark on the surface just to the left and right sides of the cutting edge.
Illustration 4 g01450675
Press the next soft key.
Turn around the machine and set the bowl in the previous location with respect to the marks.
Illustration 5 g01450679
Press the next soft key.A screen that is similar to Illustration 6 appears.
Illustration 6 g01282774
Press "Finish". The blade slope sensor is calibrated. The "Calibrate Sensors" dialog is closed. The "Setup Menu - Configuration" dialog appears.