KIT-SEAL 2395195 - Caterpillar

Warning Signs and Labels
There may be several specific safety signs on your engine. Please take the time to familiarize yourself with the safety signs.Make sure that you can read all safety signs. Clean or replace these if you cannot read the words or see the pictures. When cleaning the labels use a cloth, water and soap. Do not use solvents, gasoline, etc., to clean safety signs. The use of solvents, gasoline, etc., could loosen the sign's adhesive and cause the sign to fall off.You must replace a label if it is damaged, missing or cannot be read. If a label is attached to a part, and that part is replaced, make sure a new label is installed on the replaced part. See your Caterpillar dealer for new labels.Do not operate or work on the engine unless you have read and understand the instructions and warnings in this Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Caterpillar dealer for replacement manuals. Proper care is your responsibility.General Hazard Information
Attach a DO NOT OPERATE or similar warning tag to start switch or controls before performing maintenance or repairing the engine. These tags, SEHS7332, are available from your Caterpillar dealer. When appropriate, attach tags at the engine and at each start position and disconnect starting controls.Do not allow unauthorized personnel on or around the engine when it is being serviced.Diesel engine exhaust contains products of combustion which may be harmful to your health. Always start and operate the engine in a well ventilated area and, if in an enclosed area, vent the exhaust to the outside.Use caution when removing cover plates. Gradually loosen (do not remove) the last two bolts or nuts located at opposite ends of the cover or device. Pry cover loose to relieve any spring or other pressure, before removing the last bolts or nuts.Use caution when removing vent release valve, grease fittings, pressure taps, breathers or drain plugs. Hold a rag over the cap or plug to prevent being sprayed or splashed by liquids under pressure.* Wear a hard hat, protective glasses, hearing protection and other protective equipment as required by job conditions.* Do not wear loose clothing or jewelry that can catch on controls or other parts of the engine.* Make certain all protective guards and covers are secured in place.* Use all cleaning solutions with care.* Never put maintenance fluids into glass containers since glass containers can break.* Report all needed repairs.* Stop the engine.* Do not attempt any repairs or adjustments to the engine or driven equipment while it is running.* Do not attempt repairs you do not understand.* Ensure the protective locks or controls are in the applied position.* Be sure the remote starting system is inoperative on the equipment being serviced. Always disconnect the engine starter circuit when working on the generator. Place the automatic start-stop switch to the STOP position before working on the equipment to prevent accidental starting.* Disconnect the batteries