KIT-SEAL- 2402481 - Caterpillar

Disassembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0510 Driver Gp 1
B - 1 inch by 4 inch steel plate 2
C 248-3311 Holding Fixture 1
D 248-3310 Spanner Wrench 1
E 8H-0663 Bearing Puller Gp 1 Start By:
Remove the auxiliary water pump. Refer to Disassembly and Assembly, "Auxiliary Water Pump - Remove".
Illustration 1 g01036014
Remove plugs (1) and (2) from bearing housing (3). Remove plug (6) from housing (5). Remove the O-ring seals from the plugs.
Remove water pump filter (4) from bearing housing (3).
Illustration 2 g01035264
Remove bolts (7) and the washers. Remove bearing housing (3) from housing (5). Remove O-ring seal (8) from bearing housing (3).
Illustration 3 g01035285
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install Tooling (B) under impeller (9). Use a suitable press and Tooling (A) to remove impeller (9). Note: Do not allow bearing housing (3 ) to fall to the floor when the impeller is removed from the pump shaft.
Illustration 4 g01035309
Remove socket head bolts (10). Remove retainer (11) and pump shaft (12) from bearing housing (3). Note: Spring (14) and ceramic seal (13) will be removed from the shaft assembly when the pump shaft is removed from the bearing housing.
Illustration 5 g01035407
Install pump shaft (12) in Tooling (C). Loosen set screws (15). Use Tooling (D) to remove bearing locknut (16) from the pump shaft. Note: The splined end of the pump shaft is marked in order to indicate either RH threads or LH threads on the pump shaft.
Illustration 6 g01035429
Use Tooling (E) to remove bearing assembly (17) from pump shaft (12).
Illustration 7 g01035437
Remove ceramic seal (18) and lip seal (19) from bearing housing (3).