KIT-SEAL 2406899 - Caterpillar

Removal Procedure
Note: Put identification marks on all lines, on all hoses, on all harness assemblies, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01799874
Remove bolts (1) and guard (2) .
Illustration 2 g01799877
Disconnect harness assembly (3) .
Remove bolts (4) and modulating valve (5) .
Illustration 3 g02022585
Remove O-ring seal (6). Remove nut (7) and the washer. Remove coil assembly (8) .
Repeat Steps 3 through 1 for the remaining modulating valves.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Inspect the O-ring seals, the seals, and the gaskets. Replace the O-ring seals, the seals