KIT-SEAL- 2408525 - Caterpillar

If the engine is equipped with duplex oil filters, the engine oil filter elements can be changed during engine operation. The engine oil and filters can also be changed with the engine stopped.The oil change interval can be affected by several factors:
Air/fuel ratio
Ambient air conditions
Engine application
Fuel type
Oil type
Size of the oil sumpThe S O S oil analysis program analyzes used oil to determine if the oil change interval is suitable for your specific engine. In the absence of S O S oil analysis, change the engine oil and filters according to the intervals listed. Refer to this Operation and Maintenance Manual, "Refill Capacities" to determine the size of the oil pan.
Table 1
3512 Oil and Filter Change Intervals
Change Interval and Sump Configuration 250 Hours Shallow Sump 500 Hours Standard Sump 1000 Hours Deep Sump
Capacity Gallons Liters Gallons Liters Gallons Liters
Factory Fill 52 197 85 322 165 625
Refill with Filter Change 41 155 82 311 162 614
Sump Only Refill without Filter Change 36 136 78 296 158 599
Volume between "Add" and "Full" Marks 6 23 18 68 28 106
Table 2
3516 Oil and Filter Change Intervals
Change Interval and Sump Configuration 250 Hours Shallow Sump 1000 Hours Deep Sump
Capacity Gallons Liters Gallons Liters
Factory Fill 57 216 214 811
Refill with Filter Change 50 190 211 800
Sump Only Refill without Filter Change 42 159 206 781
Volume between "Add" and "Full" Marks 5 19 36 136 Drain the Oil
Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Cat Dealer Service Tool Catalog" or refer to Special Publication, PECJ0003, "Cat Shop Supplies and Tools Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Do not drain the oil when the engine is cold. As the oil cools, waste particles settle on the bottom of the oil pan. The waste particles are not removed when the cold oil is drained. Drain the crankcase when the oil is warm. This method allows proper draining of the waste particles that are suspended in the oil.Failure to follow this recommended procedure will allow the waste particles to be recirculated through the engine lubrication system with the new oil.
After the engine has been operated at normal operating temperature, STOP the engine.
Drain the oil according to the equipment on the engine.Note: Drain the oil into a suitable container. DO NOT drain the oil into the bilge sump. Dispose of the oil according to local regulations.
Illustration 1 g00574534
Oil drain plug
Note: If a suction device is used, ensure that the suction device is clean to keep dirt out of the oil pan. Be careful not to strike the engine oil suction tubes or the piston cooling jets.
If the engine does