KIT-SEAL 2410110 - Caterpillar

Typical Illustration Cut gaskets even with the bottom of front housing and front plate after the housing is installed on the engine.(1) Tighten two studs to a torque of ... 55 5 N m (40 4 lb ft)(2) Put 9S3263 Thread Lock on the threads of the studs. Two studs must be installed to extend above the housing surface to a dimension of ... 28.5 1.5 mm (1.12 .06 in)(3) Put 9S3263 Thread Lock on the threads of the stud. The stud must be installed to extend above the housing surface to a dimension of ... 37.0 1.5 mm (1.46 .06 in)(4) Five studs marked "X" must be installed to extend above the housing surface to a dimension of ... 28.5 1.5 mm (1.12 .06 in) Tighten studs to a torque of ... 35 5 N m (26 4 lb ft) Put 9S3263 Thread Lock on the stud serrations and each side of the gasket prior to assembly. Heads of studs must not be more than 4.5 mm (.18 in) above the surface of the timing gear plate after installation. Tighten the nuts holding the back cover in place to a torque of ... 55 5 N m (40 4 lb ft)