KIT-SEAL- 2422539 - Caterpillar

Adjust all mirrors as specified in the Operation and Maintenance Manual. Failure to heed this warning can lead to personal injury or death.
Slips and falls can result in personal injury. Use the machine's access systems when adjusting the mirrors. If the mirrors cannot be reached using the machine access systems follow the instructions found within the Operation and Maintenance Manual, "Mirror" in order to access the mirrors.
Note: Your machine may not be equipped with all the mirrors that are described in this topic.Mirrors provide additional visibility around your machine. Make sure that the mirrors are in proper working condition and that the mirrors are clean. Adjust all mirrors at the beginning of each work period and adjust the mirrors when you change operators.Shut down the machine until a damaged or any non-functioning visibility aid is repaired (if equipped). Also, shut down the machine until appropriate job site organization is used to minimize hazards that are caused by any resulting restricted visibilityThe appropriate job site organization is also recommended to minimize visibility hazards. See Operation and Maintenance Manual, "Visibility Information" for more information.Modified Machines or machines that have additional equipment or attachments may influence your visibility.Mirror Adjustment
Park the machine on a level surface.
Lower the work tool to the ground.
Move the hydraulic lockout control to the LOCKED position. For further details on this procedure, refer to Operation and Maintenance Manual, "Operator Controls".
Stop the engine.
Adjust rear view mirrors to provide visibility behind the machine at a maximum distance of 30 m (98 ft) from the rear corners of the machine.Note: You may need to use hand tools to adjust certain types of mirrors.Rear View Mirror
Illustration 1 g01960634
Rear view of interior mirror
The interior mirror can be adjusted to a position to allow the operator to see preferred areas at the rear of the machine during operations such as backing up, reversing the machine, or moving backward.Rear Mirror
Illustration 2 g01960592If equipped, adjust the rear mirror so that an area of at least 1 m (3.3 ft) from the rear of the machine can be seen from the operator seat.