KIT-SEAL 2424287 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1U-8846     Gasket Sealant        
B     9S-3263     Thread Lock Compound        Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Make sure that the threaded holes in the undercarriage frame for mounting the swivel joint are clean and free of dirt and debris.
Apply a coating of Tooling (A) to the surface of the undercarriage frame for the mounting of the swivel joint.
Attach a suitable lifting device to the swivel joint. The weight of the swivel joint is approximately 29 kg (65 lb). Place the swivel joint in the original position in the undercarriage frame. Make sure that the identification mark on the bottom face of the swivel joint is toward the front of the machine.
Illustration 1 g00564842
Install the boot and flange (11) over the swivel joint. Position flange (11) in order to install bolts (10) .
Illustration 2 g00564810
Apply a thin coat of Tooling (B) on the threads of bolts (5). Install the washers and bolts (5) in the bottom of the swivel joint.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Check the O-ring seals that are used in the ends of the hose assemblies for wear or for damage. Replace the O-ring seals, if necessary.
Install fittings (7) in the swivel joint. Install hose assemblies (6) and (8). Install hose assemblies (9) in the bottom of the swivel joint. Make sure that the hose assemblies are connected in the correct location.
Illustration 3 g00564808
Note: Replace the O-ring seals that are used in the ends of hose assemblies (2) and (3) with new O-ring seals.
Connect hose assemblies (2) and (3). Make sure that the hose assemblies are connected in the correct location. Install hose clamp (4) .
Illustration 4 g00564656
Note: Replace the O-ring seals that are used in the ends of hose assemblies (1) with new O-ring seals.
Connect hose assemblies (1). Make sure that the hose assemblies are connected in the correct locations.
Fill the hydraulic oil tank. Refer to Operation and Maintenance, "Lubricant Viscosities and Refill Capacities" for the correct filling procedure and the correct levels.