KIT-STARTING MOTOR 2427077 - Caterpillar

Machine Preparation
Clear all personnel from the machine and from the area around the machine.
Start the engine.
Illustration 2 g02449876
Engine speed dial
Set the engine speed dial at "10".
Lower the left console.
Position the machine on level ground. Check the visibility and adjust the mirrors for the best vision close to the machine.
Fully depress the service brake pedal until the service brake pedal locks mechanically.
Increase the hydraulic oil temperature to 46° to 60° C (115° to 140° F).
Fully extend the bucket cylinder and place the bucket on the ground.
Lower the stabilizers and the blade tip.
Stop the engine.
Release the pressure in the hydraulic system.Note: Refer to Testing and Adjusting, "System Pressure - Release".
Raise the left console.
Illustration 3 g03749479
Pilot pump pressure tap is located behind the left rear access door.
Connect tooling (B2) 34,450 kPa (5,000 psi) pressure sensors to the pilot pump pressure tap.Temporary Setting of the LS Cutoff Pressure for Medium Pressure Valve
Illustration 4 g03749547
Medium pressure manifold
(1) Relief valve (LS cutoff) for the medium pressure function
Loosen the locknut on relief valve (1).
Turn the adjustment screw on relief valve (1) clockwise to increase the pressure.Note: Pressure will increase 4,000 kPa (580 psi) when the adjustment screw is moved clockwise by one turn.
While the adjustment screw on relief valve (1) is being held, tighten the locknut to the specified torque.Test Procedure
Start the engine.
Set the engine speed dial at "10".
Lower the left console.
Illustration 5 g02446738
Power mode control button on the soft panel switch
Push down on the power mode control button to activate power mode.Note: The indicator light will be illuminated when power mode is activated.
Illustration 6 g02447036
Automatic Engine Speed Control (AESC) as displayed on the programmable function key in the monitor.
Disable the automatic engine speed control through the monitor by pressing the programmable button.
Illustration 7 g03722432
Hydraulic modulation switch on left joystick
Illustration 8 g06186138
Hydraulic modulation aggressive mode (monitor display)
Select the hydraulic modulation mode as aggressive. Press the lower front switch on the left joystick to select the hydraulic modulation mode.
The air conditioning should be turned off for the following test.
Stall an implement for the medium pressure circuit and hold.
Check the pressure readings at the pilot pump pressure tap. Refer to Table 1 in this manual for the correct pressure.
If the pressure is not to specification, proceed to the "Adjustment Procedure".
If the pressure is to specification, adjust line relief valve (1) on the medium pressure valve