KIT-SEAL 2603009 - Caterpillar

Illustration 7 g03206300
Illustration 8 g03325574
Install plate (12) and the gasket to flywheel housing (13) with bolts (11) and the washers.
Illustration 9 g03325887
Illustration 10 g03325375
Use Tooling (C) to install bearing (10) into adapter (4). Align the holes in bearing (10) with holes (Y) in adapter (4).
Illustration 11 g03325169
Install O-ring seal (7), thrust washer (6), and dowels (5) onto adapter (4).
Illustration 12 g03326390
If the studs were removed, refer to Table2 for the correct torque specification for the studs. Apply Tooling (D) to the threads of the studs. Install adapter (4), the washers, and nuts (3). Refer to Table 2 for the correct torque specification for nuts (3).
Table 3
Torque Table for Nuts (3) and the Studs if Necessary
Accessory Drive Gp Torque Specification for Nuts (3) Torque Specification for the Studs
137-8335, 9Y-1595, and 7N-3978 Standard Torque 110 15 N m (81 11lb ft)
8N-8161 220 25 N m (162 18 lb ft) 100 15 N m (74 11 lb ft)
121-5710 Standard Torque 115 15 N m (85 11 lb ft)
Illustration 13 g03326408
Illustration 14 g03177145
Illustration 15 g03326411
Position lip seal (9) on Tooling (A) and start the installation by hand. Allow plastic installation sleeve to kick out as the seal begins to seat in the adapter (4). Discard the plastic installation sleeve.
Use a soft brass hammer or applicable tool if needed. Tooling (A) will stop on the face of the adapter when the seal is installed to the proper depth. Lip seal (9) will be just below flush of the adapter face.
Illustration 16 g03326413
Illustration 17 g03204977
Install the dirt seal (8) uniformly by hand so it bottoms out. Illustration 17 shows a properly installed seal.Note: Dirt seal turns with the shaft while the lip seal remains stationary in the adapter.
Illustration 18 g03326416Note: The bearing surfaces of locknut (1) and the washer must be free of grease prior to installation.Note: Ensure that the inside taper on yoke (2) and the shaft is free of grease prior to the installation of the yoke.
Install yoke (2) onto the shaft. Apply Tooling (E) to the threads of locknut (1). Install the washer and locknut (1). Refer to Table 2 for the correct torque specification for locknut (1).
Table 4
Torque Table for Locknut (1)
Accessory Drive Gp Torque Specification for Locknut (1)
137-8335, 875 50 N m (645 37 lb ft)
121-5710and 9Y-1595 750 50 N m (553 37 lb ft)
7N-3978 650 50 N m (480 37 lb ft)
Use Tooling (B) and a suitable prybar to verify the end play of the shaft. The shaft end play measurement should be 0.15 mm to 0.77 mm (0.006 inch to 0.031 inch).