KIT-REPAIR 2637664 - Caterpillar

Introduction
The 9U6700 Ultrasonic Wear Indicator II Group provides a new, fast and accurate method of measuring track type machine undercarriage wear.By placing a probe on the part to be measured, the Ultrasonic Wear Indicator II will show the part thickness on the two-line alpha numeric display.The indicator also guides the operator by indicating the undercarriage components to be measured.The thickness values can be stored in internal memory for recall later. This stored information may be transferred to a computer for printing.The Custom Track Service (CTS) personal computer program, vers. 3.2, is available and when used with the Ultrasonic Wear Indicator II, will provide undercarriage wear reports directly from the stored measurements.This new CTS tool provides a professional alternative for the mechanical CTS tool kit.The Ultrasonic Wear Indicator II measures part thickness by sending high frequency sound waves through the material to be measured.When the sound reaches the opposite side of the part it is reflected back and received by the probe.The time required for the sound to travel through the part and be received determines the thickness of the part.The microprocessor in the Indicator II converts the time into a thickness value and displays it.When taking measurements, the 9U7981 Couplant must be applied to the sensing end of the probe before measuring.This allows the sound to be transferred into the part being measured.For convenience the couplant container attaches to the side of the Indicator II.Benefits Of The Ultrasonic Wear Indicator II
For many years, CTS inspectors have used the mechanical CTS kit to measure undercarriage wear. While this method worked, the new Ultrasonic Wear Indicator II has many benefits over the previous measurement method. These benefits are listed below.General Measurement Benefits
* Higher accuracy measurements - Digital display of thickness accurate to 0.1 mm (0.01")* Time savings in measuring undercarriage due to reduced cleaning and measurement storage* Easy to use - Thickness reading will always appear on the display when probe is used regardless of mode of operation.* Calibrated for undercarriage steel, but velocity can be adjusted to accurately measure other materials such as aluminum, plastic, and glass* Reads thickness of parts where opposite side is not accessible such as bulldozer blade, bucket base edge, and scraper bowl thickness* No writing - Stores readings in memory, then transfers to computer for printingUndercarriage Measurement Benefits
* Less time cleaning parts - Only a small surface on the wear area must be clean. On bushings the back side, between the bushing and shoe, does not require cleaning.* Measures track idler center flange thickness* Eliminates errors caused by dirt packed around parts* Accurately measures bushing wear after turning* Stores information from 64 machines* All CTS inspectors measure with the same accuracy. The CTS computer program will directly calculate percent wear and projected life.* Prompts CTS inspector on next reading location9U6700 Ultrasonic Wear Indicator II Group
1. 9U6701 Ultrasonic Wear Indicator II2. 4C5485 Ultrasonic Probe3. 9U7981 Couplant4. 6V7145 Carrying Case5. 4C4772 Foam Insert6. 4C3024 Battery Charger (110/220 Volts AC, 50/60 Hz)7. 9U6000 Paper TowelsNot Shown: